我的两块网卡怎么用的同一个IRQ??

ecco2005

我有2台服务器,都装的CentOS 4.4

服务器A,eth0是外网IP(1.2.3.5),eth1是内网IP(192.168.1.2),此服务器一切正常

服务器B,eth0是外网IP(1.2.3.4),eth1是内网IP(192.168.1.1)

两台服务器在大多数时候都工作正常.但有时候,服务器B的eth0会无故断流,就是连ping都ping不到.

我登录到A上,却可以ping到1.2.3.4,但是,ssh 1.2.3.4就不行

奇怪的是,当我ssh 192.168.1.1的以后,服务器B的eth0马上就恢复正常了

我查了一下服务器B的网卡配置,发现eth0和eth1居然都是使用同一个IRQ 169,这是怎么回事啊?

请问,如果要改IRQ,用什么命令? 我很害怕远程配置网卡,因为搞不好就把网弄断了,这样就麻烦了!


[root:/etc]#dmesg |grep eth
divert: not allocating divert_blk for non-ethernet device lo
divert: allocating divert_blk for eth0
eth0: Broadcom NetXtreme II BCM5708 1000Base-T (B1) PCI-X 64-bit 133MHz found at mem f8000000, IRQ 169, node addr 00188b763d5a
divert: allocating divert_blk for eth1
eth1: Broadcom NetXtreme II BCM5708 1000Base-T (B1) PCI-X 64-bit 133MHz found at mem f4000000, IRQ 169, node addr 00188b763d5c
bnx2: eth1: using MSI
bnx2: eth1 NIC Link is Up, 100 Mbps full duplex, receive & transmit flow control ON
bnx2: eth0: using MSI
bnx2: eth0 NIC Link is Up, 100 Mbps full duplex
divert: not allocating divert_blk for non-ethernet device sit0
eth0: no IPv6 routers present
eth1: no IPv6 routers present
bnx2: eth1: using MSI
ADDRCONF(NETDEV_UP): eth1: link is not ready
bnx2: eth1 NIC Link is Up, 100 Mbps full duplex, receive & transmit flow control ON
ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
bnx2: eth0: using MSI
ADDRCONF(NETDEV_UP): eth0: link is not ready
bnx2: eth0 NIC Link is Up, 100 Mbps full duplex
ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
eth1: no IPv6 routers present
eth0: no IPv6 routers present

ecco2005

没人知道吗????

cnux

共享irq，应该没什么问题的。

ecco2005

Post by cnux
共享irq，应该没什么问题的。

但是我这用着有点问题啊...

ecco2005

再顶一下~~~~~~~~

ecco2005

顶一下~~~~~~~~~~~