火球移动硬盘不能挂上，请指教

blobel

我的移动硬盘10g，是属于笔记本上硬盘拆下来装成的。
我 mount -t vfat /dev/sda1 /mnt/usb
很长时间没有响应，最后输出： /dev/sda is not a valid block device.


我fdisk /dev/sda1
输出：Unable to read /dev/sda

我#dmesg | tail -100

输出：hid-core.c: USB HID support drivers
mice: PS/2 mouse device common for all mice
EXT3 FS 2.4-0.9.18, 14 May 2002 on ide1(22,8), internal journal
Adding Swap: 522072k swap-space (priority -1)
kjournald starting.  Commit interval 5 seconds
EXT3 FS 2.4-0.9.18, 14 May 2002 on ide1(22,7), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
hda: ATAPI 6X CD-ROM drive, 128kB Cache
Uniform CD-ROM driver Revision: 3.12
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
  Vendor: ATAPI     Model: CD-R/RW 16X10     Rev: G.DJ
  Type:   CD-ROM                             ANSI SCSI revision: 02
parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE]
parport0: irq 7 detected
ohci1394: pci_module_init failed
ip_tables: (C) 2000-2002 Netfilter core team
8139too Fast Ethernet driver 0.9.25
PCI: Found IRQ 11 for device 02:04.0
divert: allocating divert_blk for eth0
eth0: RealTek RTL8139 Fast Ethernet at 0xd08da000, 00:e0:4c:5b:05:f8, IRQ 11
eth0:  Identified 8139 chip type 'RTL-8139C'
Intel 810 + AC97 Audio, version 0.22, 13:45:06 Sep  4 2002
PCI: Found IRQ 9 for device 00:1f.5
PCI: Sharing IRQ 9 with 00:1f.3
PCI: Setting latency timer of device 00:1f.5 to 64
i810: Intel ICH2 found at IO 0xe000 and 0xdc00, IRQ 9
i810_audio: Audio Controller supports 6 channels.
i810_audio: Defaulting to base 2 channel mode.
ac97_codec: AC97 Audio codec, id: 0x414c:0x4730 (Unknown)
i810_audio: only 48Khz playback available.
i810_audio: AC'97 codec 0 supports AMAP, total channels = 2
MSDOS FS: IO charset cp936
MSDOS FS: Using codepage 936
MSDOS FS: IO charset cp936
MSDOS FS: Using codepage 936
MSDOS FS: IO charset cp936
MSDOS FS: Using codepage 936
hub.c: USB new device connect on bus2/1, assigned device number 2
usb.c: USB device 2 (vend/prod 0x5e3/0x702) is not claimed by any active driver.
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
usb-uhci.c: interrupt, status 2, frame# 1117
usb_control/bulk_msg: timeout
scsi1 : SCSI emulation for USB Mass Storage devices
  Vendor: EagleTec  Model: External Hard Di  Rev: 0113
  Type:   Direct-Access                      ANSI SCSI revision: 02
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
USB Mass Storage support registered.
Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
SCSI device sda: 19640881 512-byte hdwr sectors (10056 MB)
sda: test WP failed, assume Write Enabled
sda:usb_control/bulk_msg: timeout
sda1
SCSI device (ioctl) reports ILLEGAL REQUEST.
SCSI device sda: 19640881 512-byte hdwr sectors (10056 MB)
sda: test WP failed, assume Write Enabled
sda: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
unable to read partition table
SCSI device (ioctl) reports ILLEGAL REQUEST.
SCSI device sda: 19640881 512-byte hdwr sectors (10056 MB)
sda: test WP failed, assume Write Enabled
sda: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
unable to read partition table
SCSI device (ioctl) reports ILLEGAL REQUEST.
SCSI device sda: 19640881 512-byte hdwr sectors (10056 MB)
sda: test WP failed, assume Write Enabled
sda: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
unable to read partition table
I/O error: dev 08:00, sector 0
SCSI device (ioctl) reports ILLEGAL REQUEST.
SCSI device sda: 19640881 512-byte hdwr sectors (10056 MB)
sda: test WP failed, assume Write Enabled
sda: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
unable to read partition table
SCSI device (ioctl) reports ILLEGAL REQUEST.
SCSI device sda: 19640881 512-byte hdwr sectors (10056 MB)
sda: test WP failed, assume Write Enabled
sda: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
unable to read partition table
SCSI device (ioctl) reports ILLEGAL REQUEST.
SCSI device sda: 19640881 512-byte hdwr sectors (10056 MB)
sda: test WP failed, assume Write Enabled
sda: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
unable to read partition table
I/O error: dev 08:00, sector 0
SCSI device (ioctl) reports ILLEGAL REQUEST.
SCSI device sda: 19640881 512-byte hdwr sectors (10056 MB)
sda: test WP failed, assume Write Enabled
sda: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
unable to read partition table
I/O error: dev 08:00, sector 0


请问怎样解决？

AMD-K6

.........我也不会哦~~

北南南北

把这个命令的输出帖上来
#fdisk -l /dev/sd?
试试看

georgek

這個不是ide 的hd 嗎? 把他當成scsi 有什麼用?