|
发表于 2003-4-8 21:32:37
|
显示全部楼层
我用7.0的时候还没有usb鼠标,现在在8.0里面是能够自动识别的。试试用turboxcfg设置一下。如果还是不行,看看这些:
You can use USB devices in Linux with 2.4.x kernels, or with a 2.2 kernel that is at least 2.2.18.
You will need the following kernel modules
usbcore
usb-ohci or usb-uhci or uhci
hid
mousedev
Find out which module you need for your USB interface. You choices are usb-ohci, usb-uhci or uhci.
Try loading each module with the command"modprobe [module name]".
If you get some error messages, then you didn't load the correct module, so try a different one.
Now that you have the correct USB interface driver installed, load the modules hid and mousedev.
modprobe hid
modprobe mousedev
Now you may need to add an entry to /dev for the new mouse. If you don't have the file"/dev/mice" then you will need to
add the following.
Add the device"/dev/mice" with major number 13 and minor number 63.
mknod /dev/mice c 13 63
Now if you want to use the mouse with GPM, then you will need to run"gpmconfig" and set the mouse device
to"/dev/mice" and set the type to"S/2".
If you want to use the mouse with X-Windows, then you will need to have the following lines in the mouse section of you
XF86Config file.
Option"rotocol""ImPS/2"
Option"Device""/dev/mice"
If you have similar lines in the mouse section, as you should then just change them to match the above lines.
You will need to restart X-Windows for the changes to take effect.
Now you can use your USB mouse in Linux. |
|