MIC-2352运行LFS

assouan

我在MIC-2353嵌入式电脑上运行LFS6.3内核为2.6.22.5
启动后出现如下信息：
Console: switching to color frame buffer device 80x30
fb0: Asilant 69000 frame buffer (2048k RAM detected)
Non-volatile memory driver v 1.2
Linux agpgart interface v 0.102 (c) Dave Jones
Hangcheck: starting hangcheck timer 0.9.0 (tick is 180 seconds, margin is 60 seconds)
Hangcheck: Useing get_cycles()
Serial: 8250/16550 driver $Revision: 1.90 $ 26 ports, IRQ sharing disabled
serial8250: ttyS0 at I/O 0x3f8 ( irq = 0 ) is a 16550A
serial8250: ttyS2 at I/O 0x2f8 ( irq = 3 ) is a 16550A
serial8250: ttyS10 at I/O 0x250 ( irq = 10 ) is a 16550A
serial8250: ttyS11 at I/O 0x258 ( irq = 10 ) is a 16550A
serial8250: ttyS12 at I/O 0x260 ( irq = 10 ) is a 16550A
serial8250: ttyS13 at I/O 0x268 ( irq = 10 ) is a 16550A
serial8250: ttyS14 at I/O 0x340 ( irq = 12 ) is a 16550A
serial8250: ttyS15 at I/O 0x348 ( irq = 12 ) is a 16550A
serial8250: ttyS16 at I/O 0x350 ( irq = 12 ) is a 16550A
serial8250: ttyS17 at I/O 0x358 ( irq = 12 ) is a 16550A
FDC 0 is a post-1991 82077
RAMDISK driver initialized: 16 RAM disk of 4096k size 1024 blicksize
loop: module loaded
Xd: Out of memory
Compaq SMART2 Driver ( v 2.6.0 )
HP CISS Driver ( v 3.6.14 )
v2.3: micro memory(tm) PCI memory board block driver
MM: desc_per_page=128
Intel(R) PRO/1000 Network Driver - version 7.3.20-k2
Copyright (C) 1999-2006 Intel corporation
8139cp: 10/100 PCI Ethernet driver v1.3 (Mar 22,2004)
8139cp 0000:00:0d.0: This (id 10ec:8139 rev10) is not an 8139c+ compatible chip
8139cp 0000:00:0d.0: Try the "8139too" driver instead.
8139too Fast Ethernet driver 0.9.28
PCI: setting IRQ 15 as level-triggered
PCI: Found IRQ 15 for device 000:00:0d.0
eth0: RealTek RTL8139 at 0xe400, 00:d0:c9:a9:d3:d4, IRQ 15
eth0: Identified 8139 chip type 'RTL-8100B/8139D'
Uniform Multi-platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes: voerride with idebus=xx
PIIX4: IED controller at PCI slot 0000:00:07.1
PIIX4: chipset revision 1
PIIX4: not 100% natire mode: will proble irqs later
    ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hadMA,hdb:pio
Probing IED interface ide1...
Probing IED interface ide2...
Probing IED interface ide3...
Probing IED interface ide4...
Probing IED interface ide5...
hda: 1982MB, CHS=1007/64/63
    hda: hda1
$Id: pmc551.h, v 1.6 2005/11/07 11:14:55 gleixner Exp $
Ramix PMC551 PCI Mezzanine Ram Driver. (C) 1999,2000 Nortel Networks.
pmc 551: not detected
kvm: no hardware support
has_svm: not amd
kvm: no hardware support
aoe: AoE v32 initialized
serio: i8402 KBD port at 0x60,0x64 irq 1
mice: PS/2 device common for all mice
input: AT Translated set 2 keyboard as /class/input/input0
profile: using time interrupt
TCP cubic registdred
NET: Registered protocol famkly 1
NET: Registered protocol famkly 17
Using IPI shortuct mode
Freeing unused kernel memoyt: 276k freed.
系统到此就不动了，但是能够响应键盘消息。
求大侠们帮忙！