关于Knoppix 3.2

MircoA930

Linux的各位高手，大家好！
我有一张Knoppix 3.2的刻录盘，是光驱启动的。可是，我进入节面后，不知道怎么用。希望各位高手指点用法。
谢谢！

Firebird

就直接用啊。。。。

Lunxior

..................

MircoA930

谢谢！请再具体点。

Lunxior

。。。。。。。。
启动以后不就在用了？

cuinantrue

Knoppix支持全盘复制吗？我看过一篇文章说支持，但是前提是原盘和目标盘没有设置分区。我可真糊涂了。
原文如下：

您需要两个相同大小的硬盘，或者目的盘比源盘大。确认两个硬盘上都没有设置分区。
dd命令执行精确的逐位拷贝，包括 MBR (master boot record，主引导记录)：

# dd if=/dev/hda of=/dev/hdb

jin.liu

Q: Can one also install the distribution from the CD onto a hard drive?

A: In principal, yes (after all, the "master" system also runs on a hard
drive before it is burned to CD). However there is currently no
installation GUI for this, so installation to a hard drive should probably
only be attempted by more knowledgeable Linux users. Assuming the KNOPPIX
system has already booted, installation approximately follows this
procedure:
1.) initialize a free partition with the ext2 file system and mount it on
    /mnt/knoppix, for example.
2.) cp -a /KNOPPIX/* /mnt/knoppix/
3.) set up /mnt/knoppix/etc/fstab and /mnt/knoppix/etc/lilo.conf for the
    new system (Caution: symlinks in /boot initially point to the Ram
        disk!), run lilo.
4.) mkdir /mnt/knoppix/home/knoppix && \
        chown knoppix.knoppix /mnt/knoppix/home/knoppix
5.) Reboot, try the system out, fix any broken settings.
(No guarantees.)