|
发表于 2004-4-5 22:31:18
|
显示全部楼层
我同样遇到了这个问题.
http://jeroen.ws/public/etech_usb.php
在这里或许你能找到答案.
Caveat 1: Adding the network interface
Once you have the AccessRunner driver installed and configured, you will probably run into the following. When starting the cxacru service from the command-line, everything seems to be going fine, until the DHCP part. The DHCP commands are shown, but it looks something like:
DHCPDISCOVER on nas0 to 255.255.255.255 port 67 interval 3
DHCPOFFER from 81.59.96.1
DHCPREQUEST on nas0 to 255.255.255.255 port 67
DHCPACK from 81.59.96.1
/sbin/dhclient-script: configuration for nas0 not found.
DHCPDECLINE on nas0 to 255.255.255.255 port 67
This means there is no network configuration for the nas0 interface. It is easy to remedy this: From the command line, start "netconf", go in to "Host name and IP network devices" and underneath the last eth device, fill in another device called "nas0". Set the mode to "dhcp", and the netmask to 255.255.255.224 (Don't know if this last bit is necesary, but that's what I did). Leave the rest blank, including the driver field.
After exiting netconf, restart the network and try starting cxacru again. |
|