我的声卡还没搞好

joshua-xy

我的主板芯片是kt880,声卡模块用hwd 显示是snd-via82xx已经按照http://wiki.archlinux.org/index. ... 修改modprobe.conf 及rc.conf
声卡仍不能驱动，哪位能帮帮忙？

ganloo

贴出来看看，不过我最怀疑是你没有打开声音，因为snd-via82xx是很常见的ac97模块。

qsdickee

运行alsamixer，确保里面的master和pcm打开，默认是off.

joshua-xy

#
# /etc/modprobe.conf (for v2.6 kernels)
#
alias eth1 8139too
# OSS Compatibility
install snd-pcm modprobe -i snd-pcm ; modprobe snd-pcm-oss ; true
install snd-seq modprobe -i snd-seq ; modprobe snd-seq-oss ; true

# --- BEGIN: Generated by ALSACONF, do not edit. ---
# --- ALSACONF version 1.0.9 ---
options snd-via82xx ac97_quirk=0
options snd  device_mode=0666
alias snd-card-0 snd-via82xx
alias sound-slot-0 snd-via82xx
# --- END: Generated by ALSACONF, do not edit. ---
this is  modprobe.conf
#
# /etc/rc.conf - Main Configuration for Arch Linux
#

#
# Localization
#
# HARDWARECLOCK: set to "UTC" or "localtime"
# TIMEZONE: timezones are found in /usr/share/zoneinfo
# KEYMAP: keymaps are found in /usr/share/kbd/keymaps
# CONSOLEFONT: fount in /usr/share/kbd/consolefonts (only needed for non-us)
# USECOLOR: use ANSI color sequences in startup messages
#
HARDWARECLOCK="localtime"
TIMEZONE=Beijing/Asia
KEYMAP=us
CONSOLEFONT=
USEcolor="yes"

# Scan for LVM volume groups at startup, required if you use LVM
USELVM="no"

#
# Networking
#
HOSTNAME="myhost"

#
# Module to load at boot-up (in this order)
#   (prefix a module with a ! to disable it)
#
MODULES=(via_rhine  uhci_hcd !usbserial !ide-scsi !snd-via82xx
snd-pcm-oss  !ehci-hcd  !i2c-viapro snd_via82xx !sata_via)

#
# Interfaces to start at boot-up (in this order)
# Declare each interface then list in INTERFACES
#   (prefix an interface in INTERFACES with a ! to disable it)
#
# Note: to use DHCP, set your interface to be "dhcp" (eth0="dhcp")
#eth0="dhcp"
#eth1="dhcp"
#
lo="lo 127.0.0.1"
#eth0="eth0 10.0.0.3 netmask 255.255.255.0 broadcast 10.0.0.255"
INTERFACES=(lo eth0)
lo="lo 127.0.0.2"
eth1="eth1 10.0.0.3 netmask 255.255.255.0  broadcast  10.0.0.255"
INTERFACES=(lo eth1)
#
# Routes to start at boot-up (in this order)
# Declare each route then list in ROUTES
#   (prefix a route in ROUTES with a ! to disable it)
#
gateway="default gw 10.0.0.138"
ROUTES=(gateway)

#
# Daemons to start at boot-up (in this order)
#   (prefix a daemon with a ! to disable it)
#
DAEMONS=(syslog-ng hotplug !pcmcia network netfs crond alsa)

# End of file
this is rc.conf

joshua-xy

运行alsamixer 后master音量为0 不能调，按m可关闭

qsdickee

Post by joshua-xy
运行alsamixer 后master音量为0 不能调，按m可关闭

向上方向键不行吗？那可能真是你的声卡模块没有加上了。运行alsactl store试试，如果报错，就是声卡模块不对！

joshua-xy

运行alsactl store 不报错

qsdickee

不会把？声卡坏了？

xiaoma

最近也遇到声卡的问题。
重新编译打了cko5补丁的核心，本想体验一下reiser4，没想到声卡模块没法加载。google了一下，才知道这是一个普遍问题。有个老外提出了一个变通的方法，开机时不自动加载，启动完后再手动加载。我试了一下，果然好用，但仍旧不解其原因。

xiaoma

换了2.6.12-mm1内核，好了。只是不知道什么原因。