我的网卡驱动安装有问题

jnesta

RH9 kernel-2.4.20-8
网卡：Marvell Yukon Gigabit Ethernet 10/100/1000Base-T Adapter, Copper RJ-45 千兆网卡

从网上找到的解决方法：
1. insmod sk98lin.o 提示没有相应硬件。
2. 从marvel网站上下载了驱动install-8_28.tar.bz2，安装驱动时，提示没有kernel header source，我又下载了kernel源码，安装后，再次安装驱动时，还是出现了问题，详细错误信息不太清楚，好像是no symbol什么的。不过，错误后面还有一些安装提示信息。如下：
make menuconfig
Device drivers --> Networking support --> Ethernet (1000 mbit)
提示要我选择"Marvell Yukon Chipset/SysKonnect SK98XX support"此项，可是在我的linux上没有这一项。

怎么办？

jnesta

安装驱动时的错误提示：

Check the driver (error)                                             [ failed ]
An error has occurred during the check proces which prevented
the installation from completing.
It's not possible to build a standalone sk98lin driver on this
host. The kernel don't export a neccesary symbols for the
device driver and we aren't able to load the driver.

Please compile the kernel and the driver manually.
The new driver has been installed in the /usr/src/linux
directory.

   1.) Go to the directory /usr/src/linux
   2.) For the console mode, run the command: make menuconfig
   3.) Select the options you want to compile into the kernel
   4.) Select the menu "Network Device Support"
   5.) Select "Ethernet (1000 Mbit)".
   5.) Mark "Marvell Yukon/SysKonnect SK-98xx/SK-95xx Gigabit
       Ethernet Adapter support" with (M)
   6.) Execute the command:
           make dep clean bzImage modules modules_install
   7.) Install the new kernel
Installation of sk98lin driver module failed.
Delete temp directories (done)

winters008

和你一样的问题。。。没有高手来回答一下吗？