|
先说几句废话:年前很忙,没有太多的时间总结一下配置过程。所以简略说明一下,希望对大家有所帮助!
配置的两种方法:
1 用ndiswrapper (具体资料到网上找,不做说明)
到kingnet官方下载ndiswrapper在xp下的驱动,解压缩,把net8185.inf 和 net8185.sys复制到/home (目录随便)。 编译安装ndiswrapper
ndiswrapper -i net8185.inf
然后用ndiswrapper -l 查看一下
modprobe ndiswrapper
就可以用了
如果想自动加载: ndiswrapper -m
不过这种方法,有一个问题没有验证。就是我的笔记本加载驱动后,只能用一会,然后就不动了。试了n次都是如此。后来到洋文网站上看了看,说是和BIOS的开机自检(POST)有关。如果在bios里设定全面自检的话,就不会出现这样的问题(至少洋鬼子是这样说的)。由于我的明基笔记本是insyde software bios,所以没法设置.
如果大家出现同样的问题可以更改bios试验一下.具体原理: 本人菜鸟,不明白.
补充一下,上面的可能是错误的
下面是摘录洋鬼子的话 (关于4k 8k 16k kernel)
(http://www.fedoraforum.org/forum/showthread.php?t=20472)
It was the version of ndiswrapper causing the problem ...at least causing modprobe to hang.
I retried the installing the drivers, no dice.
I ugraded the kernel from linuxant.com, make clean, reran make install for ndiswrapper. Thanks jrittvo, but modprobe still hung!
So I removed the driver (ndiswrapper -e driver), ran make clean, then removed any files pertaining to ndiswrapper ver .9
I retried with ndiswrapper version .7 (I heard it was a pretty good release) and everything worked. Afterwards I had to play around with the wlan0 settings. The settings wouldn't take, the gui would report one thing, iwconfig another but I finally got it going.
I'm posting this now from Fedora/Mozilla.
Thanks for all your help jrittvo, I agree I needed the kernel upgrade as well!!!
Thanks to all!
Mike
2 用REALTEK的Linux RTL8185L驱动
下载地址:ftp://202.65.194.211/cn/wlan/rtl ... 10.0531.2006.tar.gz
kingnet w510c WIRELESS CARD 的核心就是REALTEK RTL8185
tar xzvf rtl8185_linux_26.1010.0531.2006.tar.gz
cd rtl8185_linux_26.1010.0531.2006
然后
./makedrv
************************************************************
如果提示没有/linux/config.h文件 自己到 /usr/src/......./linux(不好意思,路径忘了,反正是内核源文件)中建立一个空白的就行了.(以上方法在FC6中通过)
touch config.h
然后在到ieee802.1--(忘了)中
make clean
回到上级目录 ./makedrv
如果我说的太烦,自己看看makedrv脚本就明白了
*************************************************************
执行完后会在多出来的那两个目录中生成几个模块文件 *.ko
然后执行 ./wlan0up (网卡的active灯就亮了,驱动成功)
然后自己配置网卡
iwlist wlan0 scanning (get ap address)
iwconfig wlan0 ap apaddress
ifconfig wlan0 ip **** netmask ****
route add default gw gwip
第一次发表文章,多多见谅 |
|