|
楼主 |
发表于 2008-4-11 08:23:54
|
显示全部楼层
终于看到解决办法了,今天回去试试看,呵呵。
For general installation and configuration instructions, look at the Arch Linux documentation and wiki. Most of the information there applies just as well to Lowarch.
Known Lowarch Problems
Here's one issue that's been coming up with some old laptops:
When rebooting after a successful install, the kernel panics with messages similar to these:
kinit: unable to mount root fs on device dev(0,0)
ERROR : failed to parse block device name for '/dev/hda2'
ERROR : root fs cannot be detected
The reason for this can be that mkinitcpio fails to discover your ide system, and therefore doesn't load the ide modules. The solution is quite simple: In the /etc/mkinitcpio.conf put in this:
MODULES="ide_generic"
Then reinstall the kernel.
You don't have to go through the whole installation procedure again, just to make this fix. Do this:
Boot the install cd/floppy.
Make whatever preparations you needed to do before starting the installation script, if there were any
Run /lowarch/setup
Set up the mount points. Don't create filesystems!
Go straight to the configuration, and fix the mkinitcpio.conf file
Install kernel
Install bootloader, just to be sure.
Reboot, and hopefully smile to your login prompt. |
|