|
楼主 |
发表于 2009-3-19 14:14:46
|
显示全部楼层
Post by Xstar;1963117
hades兄能否帮忙看下5.3的内核是否支持jmicron的IDE了?
咋看呀?俺不会,另外,我现在用2.6.27.18的内核了,自己编译的。
是这一项吗?
JMicron PATA support (PATA_JMICRON)
Enable support for the JMicron IDE controller, via the new
ATA layer.
If unsure, say N.
上边的选项是在:
- Serial ATA (prod) and Parallel ATA (experimental) drivers (ATA)
- If you want to use a ATA hard disk, ATA tape drive, ATA CD-ROM or
- any other ATA device under Linux, say Y and make sure that you know
- the name of your ATA host adapter (the card inside your computer
- that "speaks" the ATA protocol, also called ATA controller),
- because you will be asked for it.
- NOTE: ATA enables basic SCSI support; *however*,
- 'SCSI disk support', 'SCSI tape support', or
- 'SCSI CDROM support' may also be needed,
- depending on your hardware configuration.
复制代码
下边的。
PS:2.6.27.18内核也有这项,不知道是不是你要的。 |
|