|
|

楼主 |
发表于 2003-12-10 15:20:14
|
显示全部楼层
详细的
Linux version 2.4.22-1.2115.nptl (bhcompile@daffy.perf.redhat.com) (gcc version 3.2.3 20030422 (Red Hat Linux 3.2.3-6)) #1 Wed Oct 29 15:42:51 EST 2003
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 0000000017ff0000 (usable)
BIOS-e820: 0000000017ff0000 - 0000000017ff8000 (ACPI data)
BIOS-e820: 0000000017ff8000 - 0000000018000000 (ACPI NVS)
BIOS-e820: 00000000ffee0000 - 00000000fff0ffff (reserved)
BIOS-e820: 00000000fffc0000 - 0000000100000000 (reserved)
0MB HIGHMEM available.
383MB LOWMEM available.
ACPI: have wakeup address 0xc0001000
On node 0 totalpages: 98288
zone(0): 4096 pages.
zone(1): 94192 pages.
zone(2): 0 pages.
ACPI disabled because your bios is from 97 and too old
You can enable it with acpi=force
ACPI: RSDP (v000 AMI ) @ 0x000fc260
ACPI: RSDT (v001 AMIINT AMIINT10 0x00001000 MSFT 0x0100000b) @ 0x17ff0000
ACPI: FADT (v001 AMIINT AMIINT10 0x00001000 MSFT 0x0100000b) @ 0x17ff0030
ACPI: DSDT (v001 SiS 635 0x00001000 MSFT 0x0100000d) @ 0x00000000
Kernel command line: ro root=LABEL=/ rhgb
Initializing CPU#0
Detected 933.611 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 1861.22 BogoMIPS
Memory: 384736k/393152k available (1503k kernel code, 8028k reserved, 1110k data, 136k init, 0k highmem)
Dentry cache hash table entries: 65536 (order: 7, 524288 bytes)
Inode cache hash table entries: 32768 (order: 6, 262144 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer cache hash table entries: 32768 (order: 5, 131072 bytes)
Page-cache hash table entries: 131072 (order: 7, 524288 bytes)
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 256K
CPU serial number disabled.
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: After generic, caps: 0383f9ff 00000000 00000000 00000000
CPU: Common caps: 0383f9ff 00000000 00000000 00000000
CPU: Intel Pentium III (Coppermine) stepping 0a
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: Intel
ACPI: Subsystem revision 20031002
ACPI: Interpreter disabled.
PCI: PCI BIOS revision 2.10 entry at 0xfdb01, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
PCI: Using IRQ router SIS5595 [1039/0008] at 00:02.0
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16)
Starting kswapd
VFS: Disk quotas vdquot_6.5.1
pty: 2048 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS MULTIPORT SHARE_IRQ SERIAL_PCI ISAPNP enabled
ttyS0 at 0x03f8 (irq = 4) is a 16550A
ttyS1 at 0x02f8 (irq = 3) is a 16550A
Real Time Clock Driver v1.10e
NET4: Frame Diverter 0.46
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
SIS5513: IDE controller at PCI slot 00:02.5
SIS5513: chipset revision 208
SIS5513: not 100% native mode: will probe irqs later
SIS5513: SiS635 ATA 100 (2nd gen) controller
ide0: BM-DMA at 0xff00-0xff07, BIOS settings: hda MA, hdb MA
ide1: BM-DMA at 0xff08-0xff0f, BIOS settings: hdc MA, hdd MA
hda: ST380021A, ATA DISK drive
blk: queue c040cfc0, I/O limit 4095Mb (mask 0xffffffff)
hdd: ATAPI CD-ROM 52XMax, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: attached ide-disk driver.
hda: host protected area => 1
hda: 156301488 sectors (80026 MB) w/2048KiB Cache, CHS=9729/255/63, UDMA(100)
Partition check:
hda: hda1 hda2 < hda5 hda6 hda7 hda8 hda9 hda10 >
ide: late registration of driver.
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
Initializing Cryptographic API
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 4096 buckets, 32Kbytes
TCP: Hash tables configured (established 32768 bind 65536)
Linux IP multicast router 0.06 plus PIM-SM
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 159k freed
VFS: Mounted root (ext2 filesystem).
Journalled Block Device driver loaded
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Freeing unused kernel memory: 136k freed
mice: PS/2 mouse device common for all mice
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
PCI: Found IRQ 10 for device 00:02.3
PCI: Sharing IRQ 10 with 00:02.2
usb-ohci.c: USB OHCI at membase 0xd8858000, IRQ 10
usb-ohci.c: usb-00:02.3, Silicon Integrated Systems [SiS] USB 1.0 Controller (#2)
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 3 ports detected
PCI: Found IRQ 10 for device 00:02.2
PCI: Sharing IRQ 10 with 00:02.3
usb-ohci.c: USB OHCI at membase 0xd885a000, IRQ 10
usb-ohci.c: usb-00:02.2, Silicon Integrated Systems [SiS] USB 1.0 Controller
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
hub.c: 3 ports detected
usb.c: registered new driver hiddev
usb.c: registered new driver hid
hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik <vojtech@suse.cz>
hid-core.c: USB HID support drivers
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,10), internal journal
Adding Swap: 393552k swap-space (priority -1)
MSDOS FS: IO charset gb2312
MSDOS FS: IO charset gb2312
MSDOS FS: IO charset gb2312
MSDOS FS: IO charset gb2312
MSDOS FS: IO charset gb2312 |
|