|
Hp laserjet 6L
先装了 cups
再网页中联接http://localhost:631
点击add printer
Name 取hplaser
location 取donkey
continue后
Device 取parallel port #1
再选制造商和型号
完成后提示 Printer hplaser has been added successfully
但打印测试页没响应,肯定不是打印机的问题,我以前在RH9下就成功过
查看状态:
Description: aa
Location: donkey
Printer State: idle, accepting jobs.
Device URI: parallel:/dev/lp0
然后试着装hplip
刚装完,然后
http://localhost:631 add printer
结果在device 那步没有出现应有的hp的device
只有出现hp no_device_found
用命令查看没发现我的打印机,打印机接口应该没问题,因为在rh9下就能装上
重启一样
donkey@donkey:~$ hp-probe
HP Linux Imaging and Printing System (ver. 0.9.2)
Device Detection (Probe) Utility ver. 1.1
Copyright (c) 2003-5 Hewlett-Packard Development Company, LP
This software comes with ABSOLUTELY NO WARRANTY.
This is free software, and you are welcome to distribute it
under certain conditions. See COPYING file for more details.
[WARNING]: No devices found. If this isn't the result you are expecting,
[WARNING]: check to make sure your devices are properly connected.
请问我哪步有问题,或者我没装什么东西吗? |
|